Block and random copolymers built from propylene glycol, glycerol or other starters with propylene oxide and ethylene oxide. Non-toxic, efficient, leaves no spotting and picks up little moisture.
These polyether defoamers come from block or random polymerisation of propylene glycol, glycerol or other starters with propylene oxide and ethylene oxide. They are non-toxic and efficient, leave no spotting and pick up little moisture, and they stay chemically stable. That makes them a fit for most processes where silicone defoamers are ruled out. They also serve as emulsifiers, in emulsion polymerisation and in detergent formulations.
Each model below represents a different internal structure. Select the model that matches your foaming system. Values are typical and indicative, not a specification.
| Property | Capped Polyether | Polyether Defoamer Base |
|---|---|---|
| Appearance | Transparent or pale yellow oily liquid | Transparent or pale yellow oily liquid |
| Viscosity (25 °C, mPa·s) | 100-900 | 100-900 |
| Ionic type | Non-ionic | Non-ionic |
Active content, molecular weight and the ratio inside the material decide what you can build from it. Two materials with the same name can differ in the ratio that governs how the finished emulsion behaves, so the table columns are the specification you formulate against.
The models in this family differ in the properties tabulated above; those columns, rather than a product name, are what a shortlist has to be built on.
These are base chemistries for formulators rather than finished defoamers, so the trial is a formulation trial. Run it against the concentrate you intend to build: check how the material disperses, whether the emulsion stays stable over the shelf life you need, and whether the active content you calculate from the table matches what the finished batch delivers. Keep a small sample of the reference concentrate so the comparison is like for like.
Supplied as a non-hazardous good. Liquid models are packed in 25, 50 and 200 kg plastic drums or 1000 kg IBC totes; powder models in 20 kg cartons. Shelf life is 12 months in a sealed container, stored indoors and away from direct sunlight. Mix or shake before use; if diluted before use, use the diluted product within the same shift.

Download TDS (PDF) Request MSDS
The technical data sheet restates the typical property table above for purchasing and QA files. A GHS safety data sheet is issued per model on request, because classification follows the exact grade and the destination regulation.
A base chemistry for defoamer manufacturing: allyl ethers of different HLB values grafted onto low-hydrogen si
Unsaturated allyl ethers of different HLB values grafted onto low-hydrogen silicone oil. The base is low-foami
Unsaturated allyl ethers of different HLB values grafted onto low-hydrogen silicone oil. A low-foaming base th
A trimethyl-capped linear polysiloxane with a dimethylsilicone backbone. Colourless, non-toxic and low-volatil
The same grades are quoted to converters and formulators in Vietnam, Cambodia and Laos; each market page covers the foam problems we are usually asked about there.
Base chemistry, temperature, shear and current dosage. Our technical team will run a shake-down trial and recommend a model and a dose, normally within 24 hours on working days.