Polycarboxylate water reducers entrain air by nature. Too much of it weakens the concrete, leaves voids and shows up later as durability problems, yet the bubbles the air entrainer puts in have to stay.

The job is precise foam control: take out the harmful macro- and micro-foam, leave the useful entrained air where it is, and hold compressive, flexural and slump strength at full value.
A defoamer built specifically for the concrete admixture industry. It knocks down harmful macro- and micro-foam while leaving the beneficial bubbles from air-entraining agents intact.
View specifications PolyetherA silicone-free, high-carbon polyether ester built for concrete admixtures, above all polycarboxylate water reducers. It takes out the harmful foam and leaves the air-entrainer bubbles alone.
View specifications Silicone & EtherA silicone powder defoamer for dry-mix systems. The active rides on a solid carrier, so it survives high electrolyte, strong acid, strong alkali and high shear, where ordinary silicone emulsions give up.
View specificationsA high-content silicone concentrate. It does the work of a standard defoamer at a fraction of the dose, and it
Silicone & EtherA silicone-polymer emulsion defoamer that holds up in salt, heat and shear. It leaves no oil ring, no sediment
Silicone & EtherAn economical broad-spectrum defoamer for water-based systems, built for room-temperature work. It breaks foam
Silicone & EtherA modified polydimethylsiloxane emulsion at 33% active content. It breaks foam fast and disperses well, and it
Silicone & EtherA broad-spectrum room-temperature emulsion defoamer with strong foam inhibition and good dispersion. It keeps
Silicone & EtherA high-temperature silicone emulsion defoamer rated to 130 °C. It is a drop-in alternative to imported high-te
Silicone & EtherA silicone-free powder defoamer built on modified polyoxyethylene ethers. It is formulated for cationic starch
Silicone & EtherA fluorosilicone emulsion defoamer with strong acid and alkali durability and good dispersibility in hard wate
The same grade families are supplied to plants in Vietnam, Cambodia and Laos. The market pages set out the foam problems typical of those industries, country by country.
Base chemistry, temperature, shear and current dosage. Our technical team will run a shake-down trial and recommend a model and a dose, normally within 24 hours on working days.