Foam is a symptom, not a problem. Below is what causes it in each industry, what the defoamer has to survive, and which of our models are usually specified.

Surfactants, binders and pigment dispersions all pull air into the batch, and they do it at every stage: mixing, milling, let-down and application. Wh
Recommended models
Pulp washing, screening, dilution and black liquor handling all throw stable foam that traps fibre, pulp and filler. Carry-over into the sheet shows u
Recommended models
Jet dyeing, padding and high-temperature polyester cycles load the bath with surfactant and then run it hot, up to 130 °C, under shear. Most defoamers
Recommended models
Cutting, grinding and spray-cleaning fluids run hot and under shear. Their surfactant packages build dense foam that lifts metal fines and swarf into
Recommended models
A microbial culture is a delicate thing. Silicone residue, fogging and antifoam carry-over disturb the strain, and spotting shows up in the finished p
Recommended models
Landfill leachate, industrial wastewater and flue-gas desulphurisation all throw heavy, persistent foam. In FGD that foam can overload the demister an
Recommended models
Polycarboxylate water reducers entrain air by nature. Too much of it weakens the concrete, leaves voids and shows up later as durability problems, yet
Recommended models
Crude production, gas-field separation, offshore platforms, refining and delayed coking all make foam. It cuts throughput, floods separators and can c
Recommended models
Agrochemical formulations carry a heavy surfactant load and sit at extreme pH. Foam in the dilution tank and at the nozzle wastes active ingredient, a
Recommended models
Emulsion polymerisation and high-solids adhesive systems trap foam during mixing and reaction. It shows up as viscosity drift and unstable particle si
Recommended modelsBase chemistry, temperature, shear and current dosage. Our technical team will run a shake-down trial and recommend a model and a dose, normally within 24 hours on working days.