Factory-direct manufacturer · Tianjin, China · 6 defoamer types, 64 categories, 114 models

Coatings, Inks & Adhesives Defoamers

Surfactants, binders and pigment dispersions all pull air into the batch, and they do it at every stage: mixing, milling, let-down and application. What comes out the other end is craters, pinholes and orange peel, and occasionally a rejected batch.

Paint mixing room with colourant dispensing in a coatings factory

What the defoamer has to do here

What the line needs is a defoamer that breaks foam fast during mixing, holds it down through the shear of application, and does it without leaving defects of its own or costing you gloss.

Recommended

Models Usually Specified for Coatings, Inks & Adhesives

Also consider

Other Models in the Same Chemistry

Before you specify

Coatings, Inks & Adhesives: questions we get asked

Will the defoamer leave surface defects of its own?
That is the main risk in coatings, so we build it into the trial rather than answer it on paper. Craters and orange peel usually come from overdosing, not from the chemistry itself. Start at the low end of the recommended dose, draw the film down, look at it under good light, then step up only if foam persists.
Which of your coatings models should I trial first?
202 / 7501 is the usual starting point for water-based architectural and industrial coatings. For adhesives and higher-solids systems, 4416 / 2308 tends to hold better. Send us the binder system, solids content and application method and we will narrow it further.
Can the defoamer go in at let-down instead of during grinding?
Yes, but the two addition points solve different problems. Adding during grinding controls the air being beaten in; adding at let-down catches the foam the second half of the batch generates. Many customers split the dose between the two.
Markets

Buying from Southeast Asia?

The same grade families are supplied to plants in Vietnam, Cambodia and Laos. The market pages set out the foam problems typical of those industries, country by country.

Send us your foam system

Base chemistry, temperature, shear and current dosage. Our technical team will run a shake-down trial and recommend a model and a dose, normally within 24 hours on working days.