Vietnam runs some of the most demanding foam environments in Southeast Asia: high-electrolyte dye baths, recycled fibre stock, and polycarboxylate admixtures mixed at high shear. Our technical team works with converters and formulators in Vietnam on exactly these systems.

Jet and package dyeing runs hot, salty and alkaline. Surfactants from scouring and levelling agents hold air in the bath, so the liquor foams against the fabric. The visible result is mottling and rope marks; the invisible one is pump cavitation and a dyestuff dose that no longer matches the recipe.
Recycled furnish carries printing ink, starch and de-inking surfactant into the stock. Foam collects in the headbox approach flow and in the white water loop, then shows up as pin holes, coat streaks and unstable drainage on the wire.
Polycarboxylate superplasticisers are surface-active by nature, and the ester backbone foams during synthesis and again in the mixer. Entrained air costs compressive strength and leaves a surface that has to be reworked.
Processing plants and their effluent trains aerate hard. Protein and oil residues stabilise the foam, so basins overflow, COD rises and the aerators lose transfer efficiency long before the plant is hydraulically overloaded.
Photographed at the Tianjin plant: batch labelling, the QC bench that releases a batch, and the packing a liquid grade travels in.



| Model | Chemistry | Typical use | Property data |
|---|---|---|---|
| AC30 / AC50 | Silicone-polyether emulsion | Dye liquor, scouring and finishing baths | Data |
| 663-10A | Silicone-free fatty alcohol ether | Where silicone would mark the goods or foul the rollers | Data |
| 1101-2 / 1817 | Polyether ester | Polycarboxylate admixture synthesis and ready-mix | Data |
| 202 / 7501 | Mineral oil with ester | Coating colours, adhesives, general plant foam | Data |
| 2030L / 121L | Silicone-free polyether | Aeration basins and process water loops | Data |
Typical uses are indicative and describe where the grade is normally applied, not a guaranteed fit. Every property table is published on the product page.
Our team has provided technical support to converters and formulators in Vietnam, Cambodia and Laos — reviewing foam systems, recommending a starting grade and reading trial results with the customer. Everything is handled in English, by email or WhatsApp.
All grades are made at our own plant in Tianjin, in production since 2009. Every model has its own property table on this site, so a formulator can compare viscosity, active content and ionic type before asking for a sample.
Tell us the system — temperature, pH, surfactant load, how the foam behaves — and we will say which grades are worth testing and how to run the comparison. Sample quantities are small on purpose: the point is a decision, not a stock.
Send the system: base chemistry, temperature, surfactant load and how the foam behaves. We will reply with the grades worth testing and how to read the result.
Base chemistry, temperature, shear and current dosage. Our technical team will run a shake-down trial and recommend a model and a dose, normally within 24 hours on working days.