A trimethyl-capped linear polysiloxane with a dimethylsilicone backbone. Colourless, non-toxic and low-volatility, it takes heat well, has a high flash point and drops surface tension low.
201 methyl silicone oil is a linear polysiloxane with a dimethylsilicone backbone, end-capped with trimethylsilyl groups. It is colourless, non-toxic and low-volatility. The siloxane and methyl structure is what gives it its heat resistance, high flash point, electrical insulation, water repellency and lubricity. It also has a low viscosity-temperature coefficient, resists compression, keeps surface tension low and stays chemically stable. It sheds water and moisture, is non-toxic to living organisms including humans, and works across a wide temperature range.
Each model below represents a different internal structure. Select the model that matches your foaming system. Values are typical and indicative, not a specification.
| Property | 201 |
|---|---|
| Appearance | Colourless transparent oily liquid |
| Viscosity (25 °C, mPa·s) | 50-10000 |
| Density (g/cm³) | 0.963-0.992 |
| Flash point (°C) | >300 |
Active content, molecular weight and the ratio inside the material decide what you can build from it. Two materials with the same name can differ in the ratio that governs how the finished emulsion behaves, so the table columns are the specification you formulate against.
This family is published as a single model, so there is no internal comparison to make: the table above is the whole of the data we release on it.
These are base chemistries for formulators rather than finished defoamers, so the trial is a formulation trial. Run it against the concentrate you intend to build: check how the material disperses, whether the emulsion stays stable over the shelf life you need, and whether the active content you calculate from the table matches what the finished batch delivers. Keep a small sample of the reference concentrate so the comparison is like for like.
Supplied as a non-hazardous good. Liquid models are packed in 25, 50 and 200 kg plastic drums or 1000 kg IBC totes; powder models in 20 kg cartons. Shelf life is 12 months in a sealed container, stored indoors and away from direct sunlight. Mix or shake before use; if diluted before use, use the diluted product within the same shift.

Download TDS (PDF) Request MSDS
The technical data sheet restates the typical property table above for purchasing and QA files. A GHS safety data sheet is issued per model on request, because classification follows the exact grade and the destination regulation.
A base chemistry for defoamer manufacturing: allyl ethers of different HLB values grafted onto low-hydrogen si
Unsaturated allyl ethers of different HLB values grafted onto low-hydrogen silicone oil. The base is low-foami
Unsaturated allyl ethers of different HLB values grafted onto low-hydrogen silicone oil. A low-foaming base th
Block and random copolymers built from propylene glycol, glycerol or other starters with propylene oxide and e
The same grades are quoted to converters and formulators in Vietnam, Cambodia and Laos; each market page covers the foam problems we are usually asked about there.
Base chemistry, temperature, shear and current dosage. Our technical team will run a shake-down trial and recommend a model and a dose, normally within 24 hours on working days.