Factory-direct manufacturer · Tianjin, China · 6 defoamer types, 64 categories, 114 models

Defoamer Selection Checklist for Process Engineers

A structured checklist for specifying a defoamer: the seven questions to answer before you contact a supplier, and what each answer rules out.

By the ElonMek technical team · Selection Guide · Published 2026-07-09

Process engineer in a hard hat walking the production floor

1. What is the continuous phase?

Waterborne or solvent-based. This single answer rules out roughly half the catalogue: you cannot use a water-emulsion defoamer in a solvent system, and a silicone-free aqueous grade is pointless in a high-solids coating.

2. What is the operating temperature?

Ambient, up to 60 °C, or above 90 °C. Above 90 °C you need a grade explicitly rated for it. Our ND120F and 120Z are specified to 130 °C.

3. What is the shear level?

Jet dyeing, spray cleaning and high-speed machining impose far more shear than a mixing vessel. Any emulsion used there must have documented high-shear stability.

4. What is the pH, and is low pH involved?

Acid or alkali resistance narrows the choice sharply. Below pH 5, many silicone emulsions degrade; our silicone-free grades and the acid-resistant silicone ethers such as 5724 / 2918 are the ones to consider.

5. Is silicone permissible at all?

Spotted, fisheyes, paper machine deposits, fermentation contamination and engineered stone residue are all silicone problems. If the answer is no, go straight to our silicone-free polyether or fatty-alcohol-ether range.

6. Is the product solid or liquid?

Powder systems, detergents, dry mortar, starch, need a powder-grade defoamer that survives high electrolyte and high shear in dry mix.

7. Is there a membrane or downstream filter in the path?

Wastewater and FGD systems frequently pass UF or NF. Choose a defoamer that does not block membranes or reduce water yield; our PT24 grade is specified for exactly this reason.

Keep reading

Related guides

All technical guides

Range

Grades used in this application

All 64 grades

Markets

Buying from Southeast Asia?

The same grade families are supplied to textile, paper and construction plants in Vietnam, Cambodia and Laos.

Send us your foam system

Base chemistry, temperature, shear and current dosage. Our technical team will run a shake-down trial and recommend a model and a dose, normally within 24 hours on working days.