A high-fatty-acid-ester emulsion defoamer for systems where ordinary silicone is the wrong choice. It leaves no oil ring and does not block membranes, and it breaks foam fast.
This is a high-fatty-acid-ester emulsion defoamer for foaming systems where ordinary silicone grades do not fit, landfill leachate in particular. It leaves no oil ring and does not block membranes, and it breaks foam fast, disperses easily and mixes readily with water.
Each model below represents a different internal structure. Select the model that matches your foaming system. Values are typical and indicative, not a specification.
| Property | PT24 |
|---|---|
| Appearance | White emulsion |
| Viscosity (25 °C, mPa·s) | 600-4000 |
| pH | 5.5-7.5 |
| Ionic type | Non-ionic |
Carrier oil, active content and cost per kilo of active matter decide this range. The ester and polyether-ester grades are chosen where a straight mineral oil would affect the finished film or sheet; the mineral-oil grades are chosen where nothing downstream is sensitive to oil.
This family is published as a single model, so there is no internal comparison to make: the table above is the whole of the data we release on it.
Mineral-oil, ester and polyether-ester grades are the economical route for aqueous systems that do not need silicone performance. They carry a carrier oil, so trial them on the same batch you will run commercially and check for any effect on the downstream film, print or sheet: oil-based grades can change drying or appearance where silicone grades would not. Read the ten-minute foam height and the appearance of the finished product together.
Supplied as a non-hazardous good. Liquid models are packed in 25, 50 and 200 kg plastic drums or 1000 kg IBC totes; powder models in 20 kg cartons. Shelf life is 12 months in a sealed container, stored indoors and away from direct sunlight. Mix or shake before use; if diluted before use, use the diluted product within the same shift.

Download TDS (PDF) Request MSDS
The technical data sheet restates the typical property table above for purchasing and QA files. A GHS safety data sheet is issued per model on request, because classification follows the exact grade and the destination regulation.
A mineral-oil defoamer whose actives are a specialty polyether and silica. It breaks foam fast and holds inhib
The 202 grade pairs polyether ester with mineral oil and hydrophobic silica; 7501 is the waterborne version, b
A broad-spectrum polyether fatty-acid-ester defoamer that breaks or suppresses foam in aqueous systems. It is
A mineral-oil defoamer built on mineral oil, vegetable oil, a fatty acid amide and a dispersant. It gives broa
The same grades are quoted to converters and formulators in Vietnam, Cambodia and Laos; each market page covers the foam problems we are usually asked about there.
Base chemistry, temperature, shear and current dosage. Our technical team will run a shake-down trial and recommend a model and a dose, normally within 24 hours on working days.