Factory-direct manufacturer · Tianjin, China · 6 defoamer types, 64 categories, 114 models

Defoamer Selection in Oilfield Operations

Crude production, gas-field separation, offshore platforms and delayed coking each impose different constraints. Safety, salinity and temperature are the three variables that decide the specification.

By the ElonMek technical team · Application Guide · Published 2026-04-30

Three-phase separator on an oilfield production site

Flash point is a safety requirement, not a preference

In gas-field and offshore work the produced gas is frequently flammable or inerted. Our F-37 and F391 grades have a flash point above 80 °C and are specified for those duties. Do not substitute a general product into a classified area.

Low silicone content protects the product

Silicone contamination in the crude stream can poison downstream catalysts and break water-in-oil separation. Our oilfield grades deliberately keep silicone content low while retaining strong foam control, which is why they deliver a reliable product safety profile as well as foam control.

High-salinity, high-water-cut wells

Wells producing high water cut are the hardest case: the foam is both persistent and thermally aggressive. Grade 681F was co-developed with major domestic oilfields for exactly this environment and self-emulsifies in the produced water, with no oil ring and no suspended solids after high-temperature dilution. Its inhibition improves at higher liquid temperature.

Delayed coking and refining

Vacuum residue delayed coking generates large volumes of stable foam at very high temperature. Here the requirement is rapid knockdown at low dosage with no carry-over into the coke, and the F-37 / F391 and YD291 / 292 / 393 categories are used.

Keep reading

Related guides

All technical guides

Range

Grades used in this application

All 64 grades

Markets

Buying from Southeast Asia?

The same grade families are supplied to textile, paper and construction plants in Vietnam, Cambodia and Laos.

Send us your foam system

Base chemistry, temperature, shear and current dosage. Our technical team will run a shake-down trial and recommend a model and a dose, normally within 24 hours on working days.