A fluorosilicone composite defoamer for metalworking fluids. Below 0.1% it keeps foam suppressed for up to 100 hours, and it self-emulsifies in water on its own.
GP14 and GP14Y are compounded from specialty polyether and fluorosilicone raw materials in a process we run ourselves. They dissolve cleanly in the water phase, leave no sediment or floating oil, and do not cloud the working fluid. Below 0.1% of the working fluid they hold foam down for up to 100 hours. The two grades cover both water-based and oil-based systems, resist alkali and acid, and stay stable at high temperature while still breaking foam and holding it down. Both self-disperse and emulsify in water, so they handle aqueous foam and lift bubbles out of systems carrying a lot of solid powder or fibre.
Each model below represents a different internal structure. Select the model that matches your foaming system. Values are typical and indicative, not a specification.
| Property | GP14 | GP14Y |
|---|---|---|
| Appearance | Cloudy oily liquid | Cloudy oily liquid |
| Active content | ≥95.0 | ≥90.0 |
| Viscosity (25 °C, mPa·s) | 300-2000 | 300-2000 |
| pH | 5.5-7.5 | 5.5-7.5 |
Surface tension and active content decide most of it: a higher active content buys a lower dose, while the silicone-polyether block structure decides how well the grade survives heat and high shear. Ionic type matters next, because it has to match the charge of the system you are adding it to.
Across the 2 models in this family the published active content runs from ≥90.0 to ≥95.0. The table above is the only figure we publish, and it is typical rather than a specification.
Silicone and silicone-polyether grades settle the foam by lowering surface tension, so the dose that works is usually small and the risk is over-dosing rather than under-dosing. Split an already-made batch, add the grade in steps of 10 ppm up to the dose you would accept commercially, and read foam height at one minute and at ten minutes. Watch the surface as well as the foam: a silicone grade pushed too far shows as fish eyes, craters or loss of gloss before it shows as any change in the foam.
Supplied as a non-hazardous good. Liquid models are packed in 25, 50 and 200 kg plastic drums or 1000 kg IBC totes; powder models in 20 kg cartons. Shelf life is 12 months in a sealed container, stored indoors and away from direct sunlight. Mix or shake before use; if diluted before use, use the diluted product within the same shift.

Download TDS (PDF) Request MSDS
The technical data sheet restates the typical property table above for purchasing and QA files. A GHS safety data sheet is issued per model on request, because classification follows the exact grade and the destination regulation.
A high-content silicone concentrate. It does the work of a standard defoamer at a fraction of the dose, and it
A silicone-polymer emulsion defoamer that holds up in salt, heat and shear. It leaves no oil ring, no sediment
An economical broad-spectrum defoamer for water-based systems, built for room-temperature work. It breaks foam
A modified polydimethylsiloxane emulsion at 33% active content. It breaks foam fast and disperses well, and it
The same grades are quoted to converters and formulators in Vietnam, Cambodia and Laos; each market page covers the foam problems we are usually asked about there.
Base chemistry, temperature, shear and current dosage. Our technical team will run a shake-down trial and recommend a model and a dose, normally within 24 hours on working days.