Built with major oilfields for high-temperature, high-salinity production. Grafted silicone polyethers and specially modified polysiloxanes knock down foam from extraction, filtration and gathering fast.
9262-1 and 9262-2 came out of years of field work with major oilfields. The base is grafted silicone polyethers with specially modified polysiloxanes, and both grades self-emulsify. They handle high-temperature foaming systems across the board and clear foam from crude extraction, filtration and gathering quickly. In the field that shows up as a marked gain in oil recovery.
Each model below represents a different internal structure. Select the model that matches your foaming system. Values are typical and indicative, not a specification.
| Property | 9262-1 | 9262-2 |
|---|---|---|
| Appearance | White emulsion | White emulsion |
| Active content | 35.0±1.0 | 30.0±1.0 |
| Viscosity (25 °C, mPa·s) | 500-2500 | 500-2500 |
| pH | 6.0-8.0 | 6.0-8.0 |
| Ionic type | Non-ionic | Non-ionic |
Surface tension and active content decide most of it: a higher active content buys a lower dose, while the silicone-polyether block structure decides how well the grade survives heat and high shear. Ionic type matters next, because it has to match the charge of the system you are adding it to.
Across the 2 models in this family the published active content runs from 30.0±1.0 to 35.0±1.0. The table above is the only figure we publish, and it is typical rather than a specification.
Silicone and silicone-polyether grades settle the foam by lowering surface tension, so the dose that works is usually small and the risk is over-dosing rather than under-dosing. Split an already-made batch, add the grade in steps of 10 ppm up to the dose you would accept commercially, and read foam height at one minute and at ten minutes. Watch the surface as well as the foam: a silicone grade pushed too far shows as fish eyes, craters or loss of gloss before it shows as any change in the foam.
Supplied as a non-hazardous good. Liquid models are packed in 25, 50 and 200 kg plastic drums or 1000 kg IBC totes; powder models in 20 kg cartons. Shelf life is 12 months in a sealed container, stored indoors and away from direct sunlight. Mix or shake before use; if diluted before use, use the diluted product within the same shift.

Download TDS (PDF) Request MSDS
The technical data sheet restates the typical property table above for purchasing and QA files. A GHS safety data sheet is issued per model on request, because classification follows the exact grade and the destination regulation.
A high-content silicone concentrate. It does the work of a standard defoamer at a fraction of the dose, and it
A silicone-polymer emulsion defoamer that holds up in salt, heat and shear. It leaves no oil ring, no sediment
An economical broad-spectrum defoamer for water-based systems, built for room-temperature work. It breaks foam
A modified polydimethylsiloxane emulsion at 33% active content. It breaks foam fast and disperses well, and it
The same grades are quoted to converters and formulators in Vietnam, Cambodia and Laos; each market page covers the foam problems we are usually asked about there.
Base chemistry, temperature, shear and current dosage. Our technical team will run a shake-down trial and recommend a model and a dose, normally within 24 hours on working days.