By the ElonMek technical team · Application Guide · Published 2026-08-27

Dose on active content, not on product weight
Every technical data sheet for our products expresses a recommended minimum active concentration, typically 5 ppm for concentrates and 10 ppm for emulsions. This is the number that matters. A 15% emulsion at 10 ppm active requires roughly 67 ppm of product; a 50% concentrate at the same active level requires only 20 ppm. Always calculate from the active content.
Run a proper shake-down test
- Prepare 500 ml of your actual product at process concentration and temperature.
- Add defoamer at half the recommended active level and mix at the same shear used in production.
- Measure foam height after 60 s and again after 10 min. The 10-minute number is the one that predicts your shift.
- If residual foam remains, double the dose and repeat. If adding more defoamer makes the foam worse, stop and check compatibility.
Why more is not always better
Defoamers work by destabilising the foam lamella. In a severely overloaded system, an excessive dose can produce its own stable foam. The classic symptom of defoamer "shock". You will also be adding cost, and in coating or adhesive systems an overdose can cause surface defects. If you need more than roughly twice the recommended dose, the chemistry is wrong for the system.
Add order matters
Shake or stir the drum before use so the emulsion is homogeneous, then add the defoamer slowly with agitation. Diluting first in a thickened water phase often improves dispersion, but any diluted product must be used within the same shift. A diluted emulsion is not stable enough to store.
